Hey isolt, your printer looks great. And good idea with the switches on the right.
I'm not going to change the SD-Card much. I don't print so much from SD overall and if then i mostly upload the gcode via serial and let the SD just in for space. Therefore i don't care so much about SD reliability. I have long cables that i just put through the tubes below the printer and that comes out nice - still gotta decide if i put it there on the front and what case i use for that.
I still have the extruder left to build - i'll finish that first, do a little bit of calibration prints and maybe then comes to my mind where to place the smart controller :)
I'm not going to change the SD-Card much. I don't print so much from SD overall and if then i mostly upload the gcode via serial and let the SD just in for space. Therefore i don't care so much about SD reliability. I have long cables that i just put through the tubes below the printer and that comes out nice - still gotta decide if i put it there on the front and what case i use for that.
I still have the extruder left to build - i'll finish that first, do a little bit of calibration prints and maybe then comes to my mind where to place the smart controller :)